1. It is strictly forbidden to break or bend the synchronous belt excessively to avoid damage to the strong layer and loss of use value.

2. Do not store the belt in abnormal condition for a long time.

3. Keep in a cool place.

4. During the installation, please shorten the center distance, loosen the tension wheel, and do not force the timing belt to be loaded from the convex rib under the pulley.

5. The teeth of the pulley must be at right angles to the running direction of the belt.

6. The parallelism of the main shaft of the driving wheel and the driven wheel is controlled at tangent = 1 / 1000. Inaccurate shaft position directly affects the service life.

7. If it is found that the belt on the driving pulley deviates to one side, it is necessary to move the driven pulley for adjustment and adjust the pressure of the tensioning pulley.

8. During start-up, if the center distance changes, the belt loosens and tooth skipping occurs, check whether the pulley frame is loose and whether the positioning of the shaft is inaccurate. It should be adjusted and reinforced.

9. When installing the synchronous belt, it must be properly tensioned according to different models and bandwidth.

10. The tensioning wheel must be installed on the loose side of the drive.